Manual FlexiVision One#
This page collects the revision history of this manual and indicates which versions of the FlexiVision One software each revision is compatible with.
Important
Always consult the manual version that is compatible with the installed software version to access the most up-to-date information on features, safety and procedures.
Compatibility#
Manual version |
Compatible FlexiVision One software versions |
|---|---|
1.02 (current) |
v0.23, v0.24 |
1.01 |
v0.21, v0.22 |
1.00 |
v0.20, v0.21, v0.22 |
Revision history#
Version 1.02#
Publication date: 17 November 2026
Pages added
New Control Cameras section, with the pages:
Control Cameras: overview, operating sequence, use from the HMI (Setup Camera Ctrl, Setup Tool Ctrl, View Runtime, Test Tool) and quick acceptance test.
start_control_command: command format, parameters, responses to the robot and example exchanges.VisionPro Script: ToolBlock interface, script customization and Appendix A with the complete C# script.
Added the page Troubleshooting – Control Cameras with the
#Error_Control_…and#Error_Camera…messages and recommended actions.All the pages of the Control Cameras section show a banner at the top indicating that the Control Camera is an Expert function.
Pages updated
Robot-Vision Communication Protocol: added the subsection “Control camera commands” with the
start_control_<parameter>command.Troubleshooting: added the “Control Cameras” card.
Glossary: added the terms CogRecord, PMRedLine, Control Camera, ToolBlock and VisionPro.
Release Notes – Software: added the versions V. 0.23 and V. 0.24 and updated the FlexiVision One Software page.
Updated the compatibility table with the software versions v0.23 and v0.24.
Version 1.01#
Publication date: 4 September 2026
Added the Check Belt page (Disk Monitoring) to the Quickstart, and the related entry in the Setup page of the Interface Overview.
Updated the Hopper Setup section with the Wizard Steps and Wizard Time guided procedures.
Updated the Histograms section with the choice of region type for Clearances (Rectangle, Annulus Section, Circle).
Updated the Mix Applications section with the multi-model
mix_Locator_<models>commands and the protection for commands already running.Added the subsection “How to use the Start and Mix commands correctly” to the Robot-Vision Communication Protocol.
Updated the FlexiBowl® Setup section: manual keyboard entry of parameters and a warning when parameters are not synchronized.
Updated the Robot Pick section: offset format with the dot as decimal separator and a check on the Picking Offset before proceeding with Next.
Added to the Setup section the note on the user access level check.
Reorganized the Release Notes section, separating the FlexiVision One software notes from the manual notes.
Version 1.00#
Publication date: 1 August 2026
First edition of the manual.